VersaTube VS3406014420WS Instruction Manual download pdf (Page 16)

#12 SELF-DRILLING SCREW

PAGE 16

CLAMP

MOTOR CYCLE

STRAP

STRING

SIDE POST

STEP 6: CHECKING THE EAVES FOR HEIGHT AND PLUMBING THE SIDE POSTS

When all of the eave corners have been installed you must check the height of all of the eaves to make sure that they are

at the same height. Run a string line down the length of the building at the eave corner. This will show you if any of the

eaves are not the right height or the side posts are not plumb. Make adjustments to the truss height and the frame and

install (4) #12 x 3/4” self-drilling screws in each swage joint.

4 SCREWS IN EACH

JOINT

A SCREW DRIVEN INTO THE CORNER OF THE CORNER

BRACKET CAN PROVIDE AN ANCHOR FOR YOUR STRING LINE.

You can use motor cycle straps and clamps to pull the frames into

plumb. When the hat channel purlins are installed at the roof eave

corner and the hat channel girt on the side at the eave the frames

will be held in place.

1 2 ... 11 12 13 14 15 16 17 18 19 20 21 ... 45 46

No comments

VersaTube VS3406014420WS Instruction Manual Page 16