VersaTube VS3406014420WS Instruction Manual download pdf (Page 34)

STEP 2: INSTALLING ADDITIONAL SIDE PANELS

If you are installing Insulation you will now cut a piece of 6’ wide insulation 5” longer than the eave height of your building.

6’ wide insulation will be used down the full length of the building. peal the protective paper off of the double sided tape

and stick the insulation (white face in) to the tape at the bottom, pull it tight to the top girt and stick it to the top girt. The

starting end of the insulation should butt tightly up against the previous piece of insulation. The insulation will sit on top of

the 6” or 2” flap on the previous piece of insulation. If you ordered insulation with seal tabs, peal off the protective paper

and stick the tab/flap from the previous piece of insulation to the piece that you just installed. If you are installing reflective

insulation the 2” tab will slide under the previous piece of insulation. Reflective insulation has a peal off adhesive strip.

Peal off the cover paper and stick the tab to the previous piece of insulation. Repeat this installation procedure down the

entire length of the building side. Repeat on the other side of the building.

INSIDE OF BUILDING

2 “

4 “

OUTSIDE OF BUILDING

TAPE STRIP

INSIDE OF BUILDING

OUTSIDE OF BUILDING

6 “

FOIL INSULATION

FACED BLANKET

INSULATION

OPTIONAL TAPE STRIP

6’ WIDE INSULATION

6” OR 4” TAB/FLAP

LAP JOINT

2 ADDITIONAL PANELS

WHITE FACE MATERIAL

PAGE 34

1 2 ... 29 30 31 32 33 34 35 36 37 38 39 ... 45 46

No comments

VersaTube VS3406014420WS Instruction Manual Page 34