VersaTube VS3406014420WS Instruction Manual download pdf (Page 21)

INSTALLING A WALK DOOR FRAME IN SIDE OF BUILDING WITH BASE RAILS CONTINUED

INSTALLING NAILER TUBES AROUND DOOR FRAME:

In your kit you will find (1) nailer tube 1 1/2” square x 42” long with two holes. This will be attached to

the door header. You will also have (2) nailer tubes 1 1/2’ square x 81 3/4” long with 5 holes. These

will attach to the verticals that make up the door frame. Attach the door nailer tubes to the door frame

with #14 x 2” self-drilling, pan head, square drive, concealor screws (shown below left).

Install the vertical nailers first. The vertical nailers will extend from the slab to the bottom of the header

tube. If you need to cut the tube to fit, do that at this time. The vertical nailers should be flush with the

inside of the door frame. Attach with 5 screws per nailer. Now install the 42” nailer to the door header.

This nailer should sit on top of the vertical nailers. Use two screws to attach the nailer.

DOOR HEADER

DOOR FRAME VERTICALS

#14 X 2” SELF-DRILLING, PAN

HEAD, SQUARE DRIVE,

CONCEALOR SCREW.

INSTALL WITH #2 SQUARE

DRIVE BIT. (INCLUDED)

PAGE 21

1 2 ... 16 17 18 19 20 21 22 23 24 25 26 ... 45 46

No comments

VersaTube VS3406014420WS Instruction Manual Page 21