VersaTube VS3406014420WS Instruction Manual download pdf (Page 28)

INSTALLATION OF SIDE WALK DOOR TRIM (J-TRIM)

If door J-Trim is not built in to your door install it at this time.

Cut two pieces of Side J-Trim to fit from the bottom of the sheeting ledge on the slab to the top of the door frame.

Cut one piece of Top J-Trim 2” longer than the door frame. (Note that this piece of J-Trim will extend out beyond the door

frame to the ends of the Side J-Trim front flange on both sides of the door. You may want to place the Side J-Trim on

both sides of the door frame and take a measurement to check that distance before you cut the Top J-Trim.)

Attach the Side J-Trim on both sides of the door to the vertical nailers with Pan Head Self-Drilling Screws.

Clip two 1” long slits in the ends of the Top J-Trim as shown below. (Both ends of the Top J-Trim)

Now, Place the Top J-Trim on top of the Side J-Trim over the door and fold the tabs that you created at the ends of the

Top J-Trim down into the top of the Side J-Trim. Attach the Top J-Trim at both ends to the top nailer with Pan Head

Screws.

MAKE TWO CUTS 1” LONG

AND FOLD TAB DOWN INTO

SIDE J-TRIM CHANNEL

(BOTH ENDS OF TOP J-TRIM)

J-TRIM

SHEETING

LEDGE

J-TRIM

DOOR MUST

BE INSTALLED

BEFORE TRIM

PAGE 28

2” LONGER THAN

DOOR FRAME OR

OUT TO FRONT

EDGES OF J-TRIM

FRONT FLANGE

1”

CLIP

FOLD TAB DOWN

#10 PAN HEAD SCREW

1 2 ... 23 24 25 26 27 28 29 30 31 32 33 ... 45 46

No comments

VersaTube VS3406014420WS Instruction Manual Page 28